Sunday, October 10, 2010

How nipple drinking system works?

The nipple drinking system works like this:


The main water supply comes from the water tank about 3 metre higher than the ground floor. An auto booster pump is needed to maintain proper water pressure at all time. Water pressure is then dropped to approximately  1.5 bar by a main line pressure regulator with a  filter. The water with lowered pressure flows through a meter where the amount of water can be read. The water is then sent through a medicine attachment to add medicine and/ vitamins to the water supply. The filtered water is sent by a plastic pipe to all the pressure regulators of  every individual drinking lines respectively.

The pressure regulator enables to set proper water pressure in the nipple line as for difference bird's grow age requires difference water flow rate. You can adjust the water pressure and it can be checked  with the water level in the viewer tube.  The nipple lines can be flushed whenever is necessary by turning the flush handle from regulate to flush position,  water will then  flushes out through the auto flush kit installed at the end of the lines.  

Nipples are fixed into thick square plastic PVC tube. The length is of the nipple pipes is 4.27 meters and supported by either aluminum profile or GI conduit pipe. You can choose how many nipples you want per line depending on your birds per square meter ratio? Nipple lines should be positioned so that the birds travel no more than 1.6 meters to nipples. Birds can trigger water flow by pecking nipple pin side or upwards from any direction. The nipple tubes are connected with a fastening clamp to keep the pipe stable. Nipple with drip cup is always recommended for helping to keep litter dry. Every Nipple line is suspended by a winching system, and is hung at 3 metre intervals.
 
Nipple drinking systems are good for all types of poultry including layers, parent stock, broilers and free-range birds.

http://www.pristine.com.my/

6 comments:

  1. On the other hand, the hot wire AFM utilizes a series of wires strung in the air stream. The wire resistance at normal operating temperature is held constant; it will allow a set voltage through it. The air cools as it passes through the hot wire. And during this process, the wire resistance diminishes. As a result, it allows passing through more voltage. The signal of the voltage then goes to the main EFI computer. There, it allows the fuel mixture to be adjusted. And then, from the AFM, it goes to the throttle chamber.

    Flowmeter Depot

    ReplyDelete
  2. Great information, worth sharing with others. This is whole new concept for me, thank you for sharing it with us

    ReplyDelete
  3. Nice Blog Thank you for sharing information about poultry products. To Buy Nipple Drinkers in India visit Vijay Raj Poultry Equipments Pvt Ltd.

    ReplyDelete
  4. Nice Blog Thank you for sharing information about Poultry Products. To Buy Nipple Drinkers in India Visit Vijay Raj Poultry Equipments Pvt Ltd.

    ReplyDelete
  5. Nice Blog Thank you for sharing information about poultry products. To buy Poultry Nipple Drinkers in India visit Vijay Raj Poultry Equipments Pvt Ltd.

    ReplyDelete